PDF
ZENODO
Published
2025-12-01
Section
Articles
How to Cite
How to Cite
OPTIMIZATION OF THE PARAMETERS OF THE DEVICE FOR HARVESTING AND PILING CUNJUT TUPLES
Ravshanov Sh.U
Candidate of Technical Sciences, Senior Researcher
Bozorboev A.A
doctoral student Scientific-research institute of agricultural mechanization (SRIMA)-
Keywords: Sesame, mowing, stacker, installation angle
Abstract
This article presents the results of multifactorial experiments conducted according to the Hartley-3 (Ha3) plan to verify the values obtained in theoretical and single-factor experimental studies for determining the parameters of a device that cuts and piles sesame plants, as well as to establish their optimal values.
Experiments were conducted on the harvesting of the local sesame variety "Tashkent-112" for the 2025 harvest. As a result of the research, it was established that to ensure the reaping and piling of sesame bushes at the required level, the speed of the unit should be 7.2-9.6 km/h, and the installation angles of the piler relative to the direction of movement and the vertical should be 35° and 10°, respectively.
References
1. "Sesame". E.S. Oplinger; D.H. Putnam; et al. Purdue University. https://hort.purdue.edu/newcrop/afcm/sesame.html
2. O‘zbekiston Respublikasi Prezidentining 05.04.2023-yildagi “2023 yilda qishloq xo‘jaligi mahsulotlari ishlab chiqarish, qayta ishlashni kengaytirish va qo‘llab-quvvatlashning qo‘shimcha chora-tadbirlari to‘g‘risida”gi PQ-113-sonli qarori.
3. O‘zbekiston Respublikasi Prezidentining 11.11.2020 yildagi “2020-2023 yillarda Qoraqalpog‘iston Respublikasini kompleks ijtimoiy-iqtisodiy rivojlantirish chora-tadbirlar to‘g‘risida”gi PQ-4889-sonli qarori.
4. O‘zbekiston Respublikasi Vazirlar Mahkamasining 27.05.2025-yildagi “Qoraqalpog‘iston Respublikasida kunjut va mosh ekinlarini yetishtirish tizimini takomillashtirish to‘g‘risida”gi 331- sonli qarori.
5. Ravshanov Sh.U., Sherov D., Bozorboev A. Dunyoda kunjut yetishtirish dinamikasining taxlili. Yuqori samarali qishloq xo‘jalik mas’hinalarini yaratish va texnika vositalaridan foydalanish darajasini oshirishning innovasion yechimlari: Xalqaro ilmiy-texnik konferensiyasi. – Gulbahor, 2023. – B. 233-238.
6. Bozorboev A.A., Ravshanov Sh.U., Abduraxmonov Sh.X. Kunjut o‘simligini o‘rish qurilmasining asosiy konstruktiv parametrlarini asoslash. O‘zbekiston agrar fani xabarnomasi. Ilmiy-amaliy jurnal.№ 5 (17)2024.-B.123-126.
